When the temperature starts dropping and winter begins to creep in, this is when you should require your furnace. Before winter, homeowners should have done the necessary furnace repair Monroe County Michigan. This helps avoid sudden stops and malfunctioning when you need heat the most. If your furnace is over 3-5 years old, you must begin annual maintenance to keep it working efficiently. However, before you call in for professional repair, you need to check some essential parts of your furnace. Here is a guide for every homeowner.

Before Calling for Furnace Repair Monroe County Check These Parts

Here is a pointer for every homeowner before calling for furnace repair Monroe County Michigan. Before paying for professional repair, you can check if the issue is a minor one you can resolve by yourself. Note this is not an instruction to open delicate parts of your furnace system. If the case is far beyond these parts, you must immediately invite a professional furnace technician. 

1. Inspect the Power

Even if your furnace is a natural gas furnace, it will still rely on electricity. Confirm that the power switch is set to “ON” before you think of other steps. Furthermore, confirm the circuit breaker to be sure it is set to “ON” and working perfectly. If you reset the circuit breaker and it switches off again, then you should invite a qualified furnace technician.

2. Replace Your Filter

One of the common causes of heating issues is a clogged or dirty air filter. This stops fresh air from getting into the furnace. Replace your air filter if it is dirty or clogged. When you hold your filter to light and can see through it, it is still in good condition. But, if the reverse is the case, you need another air filter. It is recommended that air filters should be replaced every 2 months. You can also check the manufacturer’s guide to best handle the air filter.

3. Examine the Air Intake Vent

When the air intake vent is blocked, it will not operate properly because it will lack fresh air. The air intake pipe is located outside, so go out and check to know if it is blocked by debris. Clear the surrounding of your air intake vent, and remove any leaves or debris for free airflow.

4. Inspect the Thermostat

Here are some essential things you need to check about your thermostat. Be sure the thermostat is positioned to “Heat.” Secondly, ensure that the thermostat is set to your preferred temperature. Finally, make sure that the thermostat is activating the furnace. You can detect this by setting the temperature below the current temperature. Then, turn it back to about 5 degrees above the previous temperature. Now, listen to the furnace system to know if it is activated.

5. Examine the Blower Motor

If you stand close to the furnace when it is activated, you should be able to hear the electric blower motor working. Also, you should feel the warm air coming through the vents. The blower may have failed or stopped working if you do not hear it turn on or feel warm air from the vents. 

Conclusion

When you notice any malfunctioning with any of these parts, then you should call in a professional furnace repair Monroe County Michigan. Only a licensed and qualified furnace technician should be permitted to open your furnace system. When your furnace system works effectively and efficiently, you can enjoy your winter with your family, friends, and guests.